raid:
noraid=No RAID exists.
raid_state=RAID state
total_disk_space=Total Disk Space
free_disk_space=Free Disk Space
invalid=Invalid
raid0=RAID0
raid1=RAID1
raid1s=RAID1+Spare
raid5=RAID5
raid5s=RAID5+Spare
raid10=RAID10
raid10s=RAID10+Spare
raid50=RAID50
raid50s=RAID50+Spare
spare=Spare
disk_ok=OK
disk_faulty=Faulty
disk_missing=Missing
disk_not_present=Not Present 
disk_offline=Offline
disk_rebuilding=Rebuilding
disk_spare=Spare
disk_unassigned=Unassigned
disk_num=Disk #
repair=Repair
missing=Missing. 
header1=Edit RAID Settings
header2a=Parameter
header2b=Edit Value
header3=Change Settings?
raidlevel=RAID Level
totalMB=Total Disk Space
freeMB=Free Disk Space
mb=MB
linear=Linear
0=0
1=1
5=5
10=10
raid_per=This RAID level is not recommended due to performance reasons.<br><br>
areyousure_line1=Warning: If the RAID setting is changed, ALL data will be DELETED !
areyousure_line2=The procedure could take up to 20 min. 
areyousure_line3=Continue?
add_disk_confirm=Are you sure to add disk?
del_disk_confirm=Are you sure to remove disk?
areyousure=Warning: If the RAID level is changed, ALL data will be DELETED !<br><br>Changing the level will take a few minutes.<br><br>Continue?
areyousure_reboot=Warning: If the RAID level is changed, ALL data will be DELETED !<br><br>The disk quota of each device might be reduced to fit within the new RAID!<br><br>Changing the level will take a few minutes.<br><br>Continue?
ok=OK
cancel=Cancel
changing_wait=<br>Changing the RAID level.<br><br>It will take a few minutes, please wait while changing...<br>
changing_title=Changing Raid Level
reboot_wait=The RAID level was successfully changed. The system must now reboot. Please refresh your browser in a few minutes.
reboot_title=System Restarting
title=RAID Settings
rebuilding=REBUILDING
degraded=DEGRADED
norm=OK
type=Type
status=Status
size=Size
port=No.
part_of_unit=Member of RAID
action=Action
yes=Yes
failed=Failed
not_locked_or_presented=Not Locked/Presented
locked_but_unknown=Locked but Unknown
confirm_inserted=Before clicking 'OK' to continue, please make sure that the replacement disk is inserted. 
remove_from_raid=Remove the disk from the RAID
turn_bus_off=Turn off the bus and power of the disk
turn_bus_on_and_add_to_raid=Turn on the bus and power of the disk and add it to the RAID
are_you_sure=Are you sure you want to remove this disk from the RAID and turn off its bus and power?
are_you_sure1=Are you sure you want to turn off bus and power of this disk?
can_do_hot_swapping=The disk is removed from the RAID and its bus and power is turned off successfully.
can_do_hot_swapping1=You can unlock, remove the disk, then insert a new disk and lock it.
can_do_hot_swapping2=After that, you can go to the RAID config page, turn on the bus and power of the <br>disk and add it back to the RAID.
recommend_cold_swapping=It is not safe to perform hot-swapping!
recommend_cold_swapping1=Please turn off the appliance, replace the disk with a new one, and then turn <br>on the appliance.
recommend_cold_swapping2=The new disk will be added into the RAID automatically upon reboot.
progress=Resync Progress

hwraid:
auto_refresh=Web page refresh interval
none=none
seconds=seconds
not_supported_title=RAID Not Available
not_supported=RAID is not available on this system.
refresh_now=refresh now
port=Port
part_of_unit=Part Of Unit
status=Status
size=Size(GB)
unit=Unit
type=Type
general_raid=General RAID Settings
controller_title=RAID Settings
click_to_rescan=click to start controller rescan
set_raid_level=Set RAID level to
change_raid_level=change
raid_single=single drive
raid_0=RAID 0
raid_1=RAID 1
raid_1_s=RAID 1 + hot spare
raid_5=RAID 5
raid_5_s=RAID 5 + hot spare
raid_10=RAID 10
raid_10_S=RAID 10 + hot spare
raid_50=RAID 50
raid_50_s=RAID 50 + hot spare
raid_warn=WARNING: If the RAID level is changed, ALL logs will be DELETED! Changing the level will take a few minutes. Continue?
raid_warn_port=Warning - you are removing a port from a unit, this could degrade the unit or, worse case, break it.
chg_title=Set RAID Level...
chg_message=RAID Level will be changed upon reboot.<br><br> Please wait while the system restarts...<br><br>Please refresh your browser in a few minutes..
no_need_to_change=The RAID is working in this level, no need to change!
totalMB=Total Disk Space
freeMB=Free Disk Space
mb=MB
apply=Apply
areyousure=WARNING: If the RAID level is changed, ALL data will be DELETED !<br><br>Changing the level will take a few minutes.<br><br>Continue?
areyousure_reboot=WARNING: If the RAID level is changed, ALL data will be DELETED !<br><br>Changing the level will take a few minutes.<br><br>Continue?
enable_redun=Enable Redundancy
enable_spare=Enable Hot Spare

raidchange:
areyousure=<b>WARNING:</b> If the RAID level is changed, ALL logs will be DELETED !<br><br>Continue ?
ok=OK
cancel=Cancel

